Air Conditioning Info

Did you know that Everco, Four Seasons, and Murray are now all the same company? Their new phone number for technical support is 888-325-8886.

Several calls have come in about A/C gauges not reading when fitted to the service port (or ports).  For R-12 systems try a replacement Schrader valve or new depressor in your hose end. If that doesn’t work or if you have an R-134A system with new Schrader valves, try backing the valves out about a turn. BE CAREFUL, this may cause leaking when you disconnect. Be ready to re-tighten the valve. Don’t forget to replace the service caps when you are done!

Don’t forget, there is a direct relationship between freon pressure and temperature. If you monitor the line temperature, you can know what the pressure is. My recommendation is to use the touch or contact method to monitor any fluctuation or changes.

BROKEN FLEX PLATE

Doug visits “Ass Kicking Machine” this month.

This month I worked on a 1994 Plymouth Voyager 3.3L.  This vehicle came to us with an armload of new components.  The original technician had tentatively pinpointed what he thought were injector-triggering problems on #6 injector.  After driving this vehicle and verifying the concern, (intake backfire, bucking while accelerating and while maintaining speeds), we found no codes were stored in memory and the ignition patterns appeared good.  Checking the inputs we found, cam and crank signals were good and regular.  The camshaft sensor and crankshaft sensor were removed and visually inspected, then reinstalled with new spacer tabs.  We even removed the starter and inspected the flexplate, no rust, no wobble, sensor tone openings undamaged, torque converter bolts tight, we didn’t see any problems with the flexplate.

The vehicle was driven with the lab scope viewing the crank sensor and injector patterns. When the problem would occur, there were intermittent drop outs and false triggering of the injectors.  The lab scope was unable to provide a large enough sample to view what was happening.  Next step, I had access to a Machine called “Sumitech” and a dyno.  Sumitech interfaces with the engine computer, with its 7 trace scope capabilities I was able to get the complete picture.  Injectors 2,3,4,5 all had intermittent problems and 6 different things occurred.  Cam, crank, power and ground were all steady with no glitches.  My conclusion was poor engine controller.

The customer replaced the computer and reported (UNHAPPILY) that the problem was unchanged!  You can imagine my surprise and confusion at this turn of events.

I retrieved the vehicle after spending some time at the machine mentioned in the title.  I went back to basics and looked at the cam vs. the crank signal relationship.  I found a known good engine and did a comparison.

The known good  cam and crank sensor relationship had the cam sensor pulses occurring directly between the crank pulse groups, whereas our cam pulses were aligned with the last crank pulse in each 4 pulse group.  We removed the transmission and found a broken flex plate, in fact the center part had at one time broken completely from the outer ring and wedged itself tight again.  The old flexplate slots were about an inch off alignment compared to the new one.  After reassembly with a new flexplate the vehicle was back to normal.

 During our repair, I could find no pictures showing the cam / crank relationship.  Since, I have found a couple on the internet.  See my website (www.tec-help.com) *  see “Broken Flex Plate” I have mine posted.  NOTE:  The cam sensor signals should be dead center of the crank signal groups!